7065iSCSI_Config1.fm Draft Document for Review August 30, 2007 12:59 am
384 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 16-66 SANsurfer - Login into iSCSI target
12.Enter the SANsurfer password and click OK. A configuration refresh might be requested
by SANsurfer. Click OK to refresh the configuration.
13.Repeat steps 11 on page 383 to 12 on page 384 for each remaining target of all iSCSI
host ports.
14.After all sessions are active, (as shown in Figure 16-67 on page 385), the applications
which access these logical drives can be re-started.
To Next Page
Loading...
Need help?
General