Chapter 14. SAS configuration 1 - Windows 2003 host 323
Draft Document for Review August 30, 2007 12:59 am 7065SAS_Config1.fm
Figure 14-6 Checking the SAS HBA driver status in Device Manager
Both adapters are fine, so we can proceed with the next step.
14.3 Install DS3000 Storage Manager host software
We will install the host server components of DS3000 Storage Manager. These components
include:
SMagent
SMutil
Multipath support
SMclient (optional)
At the time of writing, in-band management is not supported on the DS3200, so we will not
install the SMagent. We will be using out-of-band management.
We will install SMutil, because this will allow us to run the
hot_add utility and hence avoid the
need to reboot the host server when adding new logical drives.
Since the host server contains two SAS HBAs, we need the multipath support.
We will also install SMclient, although this component is usually not installed on the host
server, but rather on a management workstation. In our case, we want to run the DS3000
Storage Manager GUI on the host server itself.
For exact installation steps, see Chapter 5, “Installing IBM System Storage DS3000 Storage
Manager” on page 93.
To Next Page
Loading...
Need help?
General