Chapter 10. Administration - Modify 239
Draft Document for Review August 30, 2007 12:59 am 7065Admin_Modify.fm
If you decide not to preserve the data on the target logical drive after the VolumeCopy is
completed, use Copy Manager to disable the Read-only attribute for the target logical drive.
To disable the Read-Only attribute:
1. Highlight a Logical Drive Copy, and click the Permissions button to display the Set
Permissions Window, (Figure 10-39).
Figure 10-39 Select Priority
2. Select either Read-only or Read/write and click OK.
3. The progress window and shows you when the change is completed (Figure 10-40).
Figure 10-40 Change Priority Complete
You can set the volume back to Read-only using the same procedure.
Change VolumeCopy priority
Use this option in the Copy Manager to select the rate at which a VolumeCopy completes for
a selected copy pair. You can change the copy priority for a copy pair before the VolumeCopy
begins, while the VolumeCopy has a status of In Progress, or after the VolumeCopy has
completed (for a re-copy).
To change the priority highlight the Logical Drive copy and click Priority. The “Change
Priority” window appears (Figure 10-41).
To Next Page
Loading...
