7065Admin_Configure.fm Draft Document for Review August 30, 2007 12:59 am
144 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 8-15 Select hosts to access
The selected host will now appear in the right pane to be configured. Click OK to start the
automatic configuration process. When complete, you will see the Configuration Complete
window, as in Figure 8-16.
Figure 8-16 Automatic host configuration complete
Only certain hosts will be discovered, which meet the criteria listed in “What hosts are
discovered?” on page 66. If your host does not get detected, then use the manual process
shown in the next section to configure the access.
To Next Page
Loading...
Need help?
General