7065iSCSI_Config1.fm Draft Document for Review August 30, 2007 12:59 am
352 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 16-18 SANsurfer installation - Pre-installation summary
12.After installation has completed click Done, Figure 16-19.
Figure 16-19 SANsurfer installation -Installation complete
SANsurfer is installed - we can now configure the iSCSI HBA.
16.5 Configure the iSCSI HBA network settings with SANsurfer
The basic configuration of the iSCSI HBA consists of the following tasks:
Connect SANsurfer to the host with the HBA installed
Gather data about the HBA file:
– BIOS and firmware code level
– iSCSI qualified name
– MAC address in case DHCP is planned to be used for address assignment
To Next Page
Loading...
