EasyManuals Logo

IBM DS3000 User Manual

IBM DS3000
602 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #310 background imageLoading...
Page #310 background image
7065Admin_iSCSI.fm Draft Document for Review August 30, 2007 12:59 am
278 IBM System Storage DS3000: Introduction and Implementation Guide
2. Select the iSCSI host port to be configured from the iSCSI host port drop down,
Figure 12-12.
Figure 12-12 iSCSI host ports
3. IPv4 is enabled by default. To enable IPv6, check Enable IPv6, as in Figure 12-13.
Figure 12-13 IP protocol versions
4. On the IPv4 Settings tab (Figure 12-14), click Obtain configuration automatically from
DHCP server if the host port address will be assigned dynamically via DHCP. To ensure
that the host ports always receive the same IP address, you should configure your DHCP
server to use MAC addresses as base for the address assignment.
Alternatively, click Specify configuration if you want to enter a static IP address, and
enter the address, subnet mask, and gateway.
In Advanced IPv4 Settings, you can enable native VLAN support and specify a VLAN ID
that will be used by the selected port.
Figure 12-14 IPv4 address settings
5. Figure 12-15 on page 279 shows the IPv6 settings.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM DS3000 and is the answer not in the manual?

IBM DS3000 Specifications

General IconGeneral
BrandIBM
ModelDS3000
CategoryStorage
LanguageEnglish

Related product manuals