7065Admin_iSCSI.fm Draft Document for Review August 30, 2007 12:59 am
274 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 12-7 Storage Manager - Defined mutual authentication settings
12.2 Identification and networking
Identification and networking allows you to configure the networking settings for the two iSCSI
ports on each controller, the target discovery method that can be used by initiators and an
alias for the subsystem.
12.2.1 Change Target Identification
Change Target Identification allows you to setup an alias name for the iSCSI storage
subsystem that can be seen in the iSCSI session information.
1. To setup an iSCSI target alias, click Change Target Identification.
2. Enter an alias name (DS3300 in our example in Figure 12-8), and click OK.
To Next Page
Loading...
