7065iSCSI_Config3.fm Draft Document for Review August 30, 2007 12:59 am
418 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 18-24 iSCSI initiator properties - discovery address
7. Click the Target tab to see the discovered storage subsystems, Figure 18-25. This is
obviously the same subsystem as was discovered in 18.8.1, “Configure target discovery
using iSNS server” on page 413.
Figure 18-25 iSCSI initiator properties - Discovered targets
8. Proceed with 18.8.3, “Configure login to discovered targets” on page 418 to login into the
target.
18.8.3 Configure login to discovered targets
This section describes the configuration tasks required after a target is discovered. We will
first configure on node Mara - and then repeat these steps on Ora.
To Next Page
Loading...
Need help?
General