Chapter 16. iSCSI configuration 1 - Windows 2003 with QLogic QMC4052 HBA 379
Draft Document for Review August 30, 2007 12:59 am 7065iSCSI_Config1.fm
Figure 16-60 SANsurfer - Login into iSCSI target
16.A configuration refresh might be requested by SANsurfer. Click OK to refresh the
configuration.
17.Repeat steps 15 on page 378 to 16 on page 379 for each remaining target of all iSCSI
host ports.
18.After all sessions are active, (as shown in Figure 16-61 on page 380), the applications
which access these logical drives can be re-started.
19.The authentication will now be performed automatically whenever the system re-starts.
To Next Page
Loading...
