CHAPTER57 Reporting Information to External Party
Mediant 1000 Gateway & E-SBC | User's Manual
Field Description
✔ "RELEASE_BECAUSE_NO_CONFERENCE_RESOURCES_
LEFT"
✔ "RESOURCE_BECAUSE_NO_TRANSCODING_RESOURCES_
LEFT"
✔ "RELEASE_BECAUSE_GW_LOCKED"
■ "NO_MATCH":
✔ "RELEASE_BECAUSE_UNMATCHED_CAPABILITIES"
■ "FORWARDED":
✔ "RELEASE_BECAUSE_FORWARD"
■ "GENERAL_FAILED": Any other reason
Calls with duration:
■ "NORMAL_CALL_CLEAR":
✔ "GWAPP_NORMAL_CALL_CLEAR"
■ "ABNORMALLY_TERMINATED": Anything else
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "TrmReasonCategory" for Syslog and Local
Storage, and "Termination Reason" for Web CDR History.
■ The maximum number of characters for Syslog tabular alignment is 17.
Termination
Reason
Value
[437]
Displays the Q.850 reason codes (1-127) for call termination. For example, "16"
for Normal Termination.
Note:
■ The field is included in the default CDR for RADIUS CDRs.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "h323-disconnect-cause=" (e.g., "h323-disconnect-
cause=16").
■ The maximum number of characters for Syslog tabular alignment is 5.
Termination
Reason
[410]
Displays the reason for the call termination. The field value is a string of up to
40 characters and is set to one of the following:
■ Standard Call Termination Reasons:
✔ "GWAPP_UNASSIGNED_NUMBER"
✔ "GWAPP_NO_ROUTE_TO_TRANSIT_NET"
✔ "GWAPP_NO_ROUTE_TO_DESTINATION"
✔ "GWAPP_SEND_SPECIAL_INFORMATION_TONE"
✔ "GWAPP_MISDIALED_TRUNK_PREFIX"
✔ "GWAPP_CHANNEL_UNACCEPTABLE"
✔ "GWAPP_CALL_AWARDED_AND"
✔ "GWAPP_PREEMPTION"
✔ "PREEMPTION_CIRCUIT_RESERVED_FOR_REUSE"
✔ "GWAPP_NORMAL_CALL_CLEAR"
- 1009 -
To Next Page
Loading...
