CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ [1] = During Call Establishment - DTMF digits
after * or # (inclusive) are sent as Keypad only
during call establishment and call disconnect.
During an established call, all digits are sent as
DTMF.
■ [2] = Always - DTMF digits after * or #
(inclusive) are always sent as Keypad (call
establishment, connect, and disconnect).
For more information, see Interworking Keypad
DTMFs for SIP-to-ISDN Calls.
Note:
■ This feature is not applicable to re-INVITE
messages.
■ The parameter is applicable only to digital
interfaces.
Digit Collection and Dial Plan Parameters
The digit collection and dial plan parameters are described in the table below.
Table 68-37:Digit Collection and Dial Plan Parameters
Parameter Description
'Dial Plan Index'
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> dial-plan-index
[DialPlanIndex]
Defines the Dial Plan index to use in the external
Dial Plan file. The Dial Plan file is loaded to the
device as a .dat file (converted using the
DConvert utility). The Dial Plan index can be
defined globally or per Tel Profile.
The valid value range is 0 to 7, where 0 denotes
PLAN1, 1 denotes PLAN2, and so on. The default
is -1, indicating that no Dial Plan file is used.
Note:
■ If the parameter is configured to select a Dial
Plan index, the settings of the parameter
DigitMapping are ignored.
■ If the parameter is configured to select a Dial
Plan index from an external Dial Plan file, the
device first attempts to locate a matching digit
pattern in the Dial Plan file, and if not found,
then attempts to locate a matching digit
pattern in the Digit Map rules configured by
the DigitMapping parameter.
■ Digital interfaces: The parameter is also
applicable to ISDN with overlap dialing.
- 1226 -
To Next Page
Loading...
