AudioCodes E-SBC - HTTP Proxy Parameters

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
For more information, see
Configuring QoS-Based Routing
by Routing Server.
'Topology Status'
configure system > http-services >
routing-server-group-status
[RoutingServerGroupStatus]
Enables the reporting of the
device's topology status (using
the REST TopologyStatus API
command) to HTTP remote
hosts.
■ [0] Disable (default)
■ [1] Enable
For more information, see
Configuring HTTP Services.
HTTP Proxy Parameters
The HTTP Proxy service parameters are described in the table below.
Table 68-71:HTTP Proxy Service Parameters
Parameter Description
'HTTP Proxy Application'
configure network > http-proxy >
http-proxy-app
[HTTPProxyApplication]
Enables the HTTP Proxy application.
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect,
a device reset is required.
'HTTP Proxy Debug Level'
configure network > http-proxy >
http-proxy-debug-level
[HTTPProxySyslogDebugLevel]
Enables debugging of HTTP services
and the filtering of the messages sent
to the Syslog server by severity
(debug) level.
■ [0] No Debug = (Default) Disable.
■ [1] Info = Enables debug and
sends basic information in Syslog.
■ [2] Notice = Enables debug and
sends normal but significant
information in Syslog.
■ [3] Warning = Enables debug and
sends warning conditions in
Syslog.
■ [4] Error = Enables debug and
sends error conditions in Syslog.
■ [5] Critical = Enables debug and
sends critical conditions in Syslog.
■ [6] Alert = Enables debug and
sends conditions in Syslog that
require immediate action.
- 1371 -