AudioCodes E-SBC - Services

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Energy Detector Parameters
'Enable Energy Detector'
configure voip > media
ipmedia > energy-detector-
enable
[EnableEnergyDetector]
Enables the Energy Detector feature. This feature
generates events (notifications) when the signal
received from the PSTN is higher or lower than a user-
defined threshold (defined by the
EnergyDetectorThreshold parameter).
■ [0] Disable (default)
■ [1] Enable
'Energy Detector Quality Factor'
configure voip > media
ipmedia > energy-detector-
sensitivity
[EnergyDetectorQualityFactor]
Defines the Energy Detector's sensitivity level.
The valid range is 0 to 10, where 0 is the lowest
sensitivity and 10 the highest sensitivity. The default is
4.
'Energy Detector Threshold'
configure voip > media
ipmedia > energy-detector-
threshold
[EnergyDetectorThreshold]
Defines the Energy Detector's threshold. A signal
below or above this threshold invokes an 'Above' or
'Below' event.
The threshold is calculated as follows:
Actual Threshold = -44 dBm +
(EnergyDetectorThreshold * 6)
The valid value range is 0 to 7. The default is 3 (i.e., -26
dBm).
Pattern Detection Parameters
Note: For an overview on the pattern detector feature for TDM tunneling, see DSP Pattern
Detector.
'Enable Pattern Detector'
[EnablePatternDetector]
Enables the Pattern Detector (PD) feature.
■ [0] Disable (default)
■ [1] Enable
[PDPattern] Defines the patterns that can be detected by the
Pattern Detector.
The valid range is 0 to 0xFF.
Note: For the parameter to take effect, a device reset
is required.
[PDThreshold] Defines the number of consecutive patterns to trigger
the pattern detection event.
The valid range is 0 to 31. The default is 5.
Note: For the parameter to take effect, a device reset
is required.
Services
This section describes services-related parameters.
- 1364 -