AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
enable-ids
[EnableIDS]
■ [1] Enable
'Alarm Clear Period'
alarm-clear-period
[IDSAlarmClearPeriod]
Defines the interval (in seconds) after which an IDS alarm is
cleared from the Active Alarms table if no thresholds are
crossed during this time. However, this "quiet" period must
be at least twice the Threshold Window value. For example,
if IDSAlarmClearPeriod is set to 20 sec and the Threshold
Window is set to 15 sec, the IDSAlarmClearPeriod
parameter is ignored and the alarm is cleared only after 30
seconds (2 x 15 sec).
The valid value is 0 to 86400. The default is 300.
'Excluded Response Codes'
excluded-responses
[IDSExcludedResponseCode
s]
Defines the SIP response codes that are excluded form the
IDS count for SIP dialog establishment failures.
The valid value is 400 through to 699. The maximum length
is 100 characters. You can configure the parameter with
multiple codes, where each code is separated by a comma
(without spaces). The default is
408,422,423,480,481,486,487,500,501,502,503,504,505,60
0.
For more information, see Configuring SIP Response Codes
to Exclude from IDS on page153.
Note:
■ The parameter applies only to rejected responses
received from the remote network; not rejected
responses generated by the device (except for 404).
■ The response codes 401 and 407 are considered
authentication failures and therefore, are not applicable
to this parameter.
OCSP Parameters
The Online Certificate Status Protocol (OCSP) parameters are described in the table below.
Table 68-27:OCSP Parameters
Parameter Description
'Enable OCSP Server'
configure network > ocsp > enable
[OCSPEnable]
Enables or disables certificate
checking using OCSP.
■ [0] Disable (default)
■ [1] Enable
For a description of OCSP, see
Configuring Certificate Revocation
Checking (OCSP).
'Primary Server IP'
configure network > ocsp > server-ip
[OCSPServerIP]
Defines the IP address of the OCSP
server.
The default IP address is 0.0.0.0.
- 1145 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English