CHAPTER13 Network
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
The valid value of the prefix length depends on the IP
address version:
â– IPv4: 0 to 31 (default is 16)
â– IPv6: 64 (default is 64)
'Default Gateway'
gateway
[InterfaceTable_Gateway]
Defines the IP address of the default gateway for the IP
interface. When traffic is sent from this interface to an
unknown destination (i.e., not in the same subnet and not
defined for any static routing rule), it is forwarded to this
default gateway.
By default, no value is defined.
When configuring a prefix length value of 31 (for IPv4
point-to-point connections), configure the peer IP address
as the Default Gateway IP address.
DNS
'Primary DNS'
primary-dns
[InterfaceTable_
PrimaryDNSServerIPAddress]
Defines the primary DNS server's IP address (in dotted-
decimal notation), which is used for translating domain
names into IP addresses for the interface.
By default, no IP address is defined.
'Secondary DNS'
secondary-dns
[InterfaceTable_
SecondaryDNSServerIPAddress]
Defines the secondary DNS server's IP address (in
dotted-decimal notation), which is used for translating
domain names into IP addresses for the interface.
By default, no IP address is defined.
Networking Configuration Examples
Examples of IP network interface configuration are listed below:
â– Single IP network interface for all applications:
The IP Interfaces table is configured with a single interface for OAMP, Media and Control:
Inde-
x
Name
Applic-
ation Type
Eth-
ernet
Device
Inter-
face
Mode
IP
Address
Prefix
Lengt-
h
Default
Gateway
0 myInterfac
e
OAMP +
Media +
Control
1 IPv4
Manual
192.168.0.
2
16 192.168.0.
1
Two routes are configured in the Static Routes table for directing traffic for subnet
201.201.0.0/16 to 192.168.11.10, and all traffic for subnet 202.202.0.0/16 to 192.168.11.1:
Index Destination Prefix Length Gateway
0 201.201.0.0 16 192.168.11.10
1 202.202.0.0 16 192.168.11.1
The NTP applications remain with their default application types.
- 102 -