AudioCodes E-SBC

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure voip > gateway dtmf-
supp-service supp-service-
settings > nrt-subscription
[EnableNRTSubscription]
■ [0] Disable (default)
■ [1] Enable
'AS Subscribe IP Group ID'
configure voip > gateway dtmf-
supp-service supp-service-
settings > as-subs-ipgroupid
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the
Application server for Subscription.
The valid value range is 1 to 8. The default is
-1 (i.e., not configured).
'NRT Subscribe Retry Time'
configure voip > gateway dtmf-
supp-service supp-service-
settings > nrt-sub-retry-time
[NRTSubscribeRetryTime]
Defines the Retry period (in seconds) for
Dialog subscription if a previous request
failed.
The valid value range is 10 to 7200. The
default is 120.
'Call Forward Ring Tone ID'
configure voip > gateway dtmf-
supp-service supp-service-
settings > cfe-ring-tone-id
[CallForwardRingToneID]
Defines the ringing tone type played when
call forward notification is accepted.
The valid value range is 1 to 5. The default is
1.
Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
Table 68-42:MWI Parameters
Parameter Description
'Enable MWI'
configure voip > gateway
dtmf-supp-service supp-
service-settings >
enable-mwi
[EnableMWI]
Enables Message Waiting Indication (MWI).
■ [0] Disable (default)
■ [1] Enable
Note:
■ The parameter is applicable only to FXS interfaces.
■ The device supports only the receipt of SIP MWI
NOTIFY messages (the device doesn't generate
these messages).
■ For more information on MWI, see Message
Waiting Indication.
'MWI Analog Lamp'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
analog-lamp
[MWIAnalogLamp]
Global parameter enabling the visual display of MWI.
You can also configure the feature per specific calls,
using Tel Profiles (TelProfile_MWIAnalog). For a
detailed description of the parameter and for configuring
the feature in the Tel Profiles table, see Configuring Tel
Profiles.
Note:
- 1244 -