CHAPTER6 Web-Based Management
Mediant 1000 Gateway & E-SBC | User's Manual
ii. Click Yes to confirm; the changes are save to flash memory.
● If a device reset is required:
i. On the toolbar, click Reset; the Maintenance Actions page opens.
ii. Click Reset; the device saves the changes to flash memory and then resets.
When you click Apply, your changes are saved only to the device's volatile memory
and thus, revert to their previous settings if the device later undergoes a hardware reset,
a software reset (without saving to flash) or powers down. Therefore, make sure that
you save your configuration to the device's flash memory.
Configuring Table Parameters
A typical configuration table is shown below and subsequently described:
Table 6-2: General Description of Configuration Tables
Item# Button Description
1 - Page title (i.e., name of table). The page title also displays the number of
configured rows as well as the number of invalid rows. For more
information on invalid rows, see Invalid Value Indications.
- 25 -
To Next Page
Loading...
Need help?
General
