AudioCodes E-SBC

CHAPTER4 Configuring VoIP LAN Interface for OAMP
Mediant 1000 Gateway & E-SBC | User's Manual
4 Configuring VoIP LAN Interface for OAMP
You can change the device's default OAMP IP address, using any of the following methods:
■ Embedded HTTP/S-based Web server (see Web Interface)
■ Embedded CLI (see CLI)
■ ini file (see Changing OAMP Address through ini File on page15
Changing OAMP Address through Web Interface
You can change the device's default OAMP networking address through the Web- based
management tool (Web interface). The default IP address is used to initially access the device.
➢ To change the default OAMP network address through Web interface:
1. Connect Ethernet port 0/1 or 0/2 located on the CPU module directly to the network interface of
your computer, using a straight-through Ethernet cable.
2. Change the IP settings of your computer to correspond with the default OAMP IP address and
subnet mask of the device.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the default IP
address of the device; the Web interface's Web Login screen appears:
- 12 -