CHAPTER26 Manipulation
Mediant 1000 Gateway & E-SBC | User's Manual
â– Source Phone Number Manipulation for Tel-to-IP Calls table: ini file
[SourceNumberMapTel2IP] or CLI (configure voip > gateway manipulation src-
number-map-tel2ip)
➢ To configure a number manipulation rule:
1. Open the required Phone Number Manipulation table (Setup menu > Signaling & Media tab >
Gateway folder > Manipulation > Dest Number IP->Tel, Dest Number Tel->IP, Source
Number IP->Tel, or Source Number Tel->IP).
2. Click New; the following dialog box appears:
3. Configure a number manipulation rule according to the parameters described in the table below.
4. Click Apply.
The table below shows configuration examples of Tel-to-IP source phone number manipulation
rules configured in the Source Phone Number Manipulation for Tel-to-IP Calls table:
Table 26-1: Configuration Examples of Source Phone Number Manipulation for Tel-to-IP Calls
Parameter Rule 1 Rule 2 Rule 3 Rule 4 Rule 5
Destination Phone Pattern 03 * * [6,7,8]
Source Phone Pattern 201 1001 123451001# [30-40]x 2001
Stripped Digits From Left - 4 - - 5
Stripped Digits From
Right
- - - 1 -
Prefix to Add 971 5 - 2 3
Suffix to Add - 23 8 - -
Number of Digits to Leave - - 4 - -
Presentation Allowed Restricted - - -
Below is a description of each rule:
â– Rule 1: When the destination number has the prefix 03 (e.g., 035000), source number prefix
201 (e.g., 20155), and from source IP Group ID 2, the source number is changed to, for
example, 97120155.
â– Rule 2: When the source number has prefix 1001 (e.g., 1001876), it is changed to 587623.
â– Rule 3: When the source number has prefix 123451001 (e.g., 1234510012001), it is changed to
20018.
â– Rule 4: When the source number has prefix from 30 to 40 and a digit (e.g., 3122), it is changed
to 2312.
â– Rule 5: When the destination number has the prefix 6, 7, or 8 (e.g., 85262146), source number
prefix 2001, it is changed to 3146.
- 614 -
To Next Page
Loading...
Need help?
General
