EasyManuals Logo

AudioCodes E-SBC User Manual

AudioCodes E-SBC
1414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #625 background imageLoading...
Page #625 background image
CHAPTER25 Routing
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
â–  "QoS Low" = Poor Quality of Service (QoS) of the
destination.
â–  "DNS Error" = No DNS resolution. This status is
applicable only when a domain name is used (instead of
an IP address).
â–  "Not Available" = Destination is unreachable due to
networking issues.
Match
'Source Trunk Group ID'
src-trunk-group-id
[PREFIX_SrcTrunkGroupID]
Defines the Trunk Group from where the call is received.
To denote any Trunk Group, use the asterisk (*) symbol. By
default, no Trunk Group is defined (-1).
'Source Phone Pattern'
src-phone-pattern
[PREFIX_SourcePrefix]
Defines the prefix and/or suffix of the calling (source)
telephone number. You can use special notations for
denoting the prefix. For example, [100-199](100,101,105)
denotes a number that starts with 100 to 199 and ends with
100, 101 or 105. To denote any prefix, use the asterisk (*)
symbol (default) or to denote calls without a calling number,
use the $sign. For a description of available notations, see
Dialing Plan Notation for Routing and Manipulation Tables.
The number can include up to 50 digits.
'Source Tags'
src-tags
[PREFIX_SrcTags]
Assigns a Dial Plan tag to denote a group of users by calling
(source) number prefixes and/or suffixes.
The valid value is a string of up to 20 characters. The tag is
case insensitive.
To configure Dial Plan tags, see Configuring Dial Plans.
Note:
â–  The tag must belong to the Dial Plan that is assigned for
Tel-to-IP routing. To do this, use the 'Tel-to-IP Dial Plan
Name' (Tel2IPDialPlanName) parameter.
â–  The device uses the tag before or after manipulation,
depending on the 'Tel To IP Routing Mode'
(RouteModeTel2IP) parameter. If configured to Route
calls before manipulation, the tag is used before
manipulation. If configured to Route calls after
manipulation, the tag is used after manipulation.
'Destination Phone Pattern'
dst-phone-pattern
[PREFIX_DestinationPrefix]
Defines the called (destination) telephone number.
- 587 -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes E-SBC and is the answer not in the manual?

AudioCodes E-SBC Specifications

General IconGeneral
BrandAudioCodes
ModelE-SBC
CategoryGateway
LanguageEnglish

Related product manuals