CHAPTER26 Manipulation
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'Name'
manipulation-name
[_ManipulationName]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters.
Note: Each row must be configured with a unique name.
Match
'Destination Phone
Pattern'
dst-pattern
[_DestinationPrefix]
Defines the destination (called) telephone number.
You can use special patterns (notations) to denote the number.
For example, "[100-199](100,101,105)" denotes a number that
starts with 100 to 199 and ends with 100, 101 or 105. You can
use the dollar ($) sign to denote calls without a called number.
For available notations, see Dialing Plan Notation for Routing
and Manipulation Tables.
The default value is the asterisk (*) symbol, meaning any
destination number.
'Source Phone Pattern'
src-pattern
[_SourcePrefix]
Defines the source (calling) telephone number.
You can use special patterns (notations) to denote the number.
For example, "[100-199](100,101,105)" denotes a number that
starts with 100 to 199 and ends with 100, 101 or 105. You can
also use the dollar ($) sign to denote calls without a calling
number. For available patterns, see Dialing Plan Notation for
Routing and Manipulation Tables.
The default value is the asterisk (*) symbol, meaning any source
number.
'Calling Name Pattern'
calling-name-
pattern
[_CallingNamePrefix]
Defines the caller name (i.e., caller ID).
You can use special patterns (notations) to denote the calling
name. For example, to denote calls without a calling name, use
the dollar ($) sign. For available patterns, see Dialing Plan
Notation for Routing and Manipulation Tables.
The default value is the asterisk (*) symbol, meaning any calling
name.
'Source Trunk Group ID'
src-trunk-group-id
[_SrcTrunkGroupID]
Defines the source Trunk Group ID from where the Tel-to-IP call
was received.
The default value is -1, which denotes any Trunk Group.
Note: The parameter is applicable only to the Calling Name
Manipulation for Tel-to-IP Calls table.
'Source IP Address'
src-ip-address
[_SourceAddress]
Defines the source IP address of the caller for IP-to-Tel calls.
The source IP address appears in the SIP Contact header in the
INVITE message.
The default value is the asterisk (*) symbol (i.e., any IP address).
The source IP address can include the following wildcards:
â– "x" wildcard: represents single digits. For example, 10.8.8.xx
represents all IP addresses between 10.8.8.10 to 10.8.8.99.
â– "*" (asterisk) wildcard: represents any number between 0 and
255. For example, 10.8.8.* represents all IP addresses
between 10.8.8.0 and 10.8.8.255.
- 621 -
To Next Page
Loading...
Need help?
General
