CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Note: This parameter is used only for backward
compatibility. For loading (importing) Dial Plan files, use the
Dial Plan table instead (see Importing Dial Plans on
page497).
[UserInfoFileName] Defines the name of the file containing the User Information
data.
For the ini file, the name must be enclosed by single
apostrophes, for example, 'userinfo_us.dat'.
Note: The parameter is only used for backward compatibility.
Automatic Update Parameters
The automatic update of software and configuration files parameters are described in the table
below.
Auxiliary file upload through TFTP is not supported by HA mode.
Table 68-8: Automatic Update of Software and Configuration Files Parameters
Parameter Description
General Automatic Update Parameters
CLI path: configure system > automatic-update
update-firmware
[AutoUpdateCmpFile]
Enables the Automatic Update mechanism for the cmp file.
â– [0] = (Default) The Automatic Update mechanism doesn't
apply to the cmp file.
â– [1] = The Automatic Update mechanism includes the cmp
file.
Note: For the parameter to take effect, a device reset is
required.
update-frequency
[AutoUpdateFrequency]
Defines the periodic interval (in minutes) that the device waits
between consecutive automatic updates.
The default is 0 (i.e., the update at fixed intervals mechanism
is disabled).
Note: For the parameter to take effect, a device reset is
required.
predefined-time
[AutoUpdatePredefinedTime]
Defines schedules (time of day) for performing automatic
updates.
The format syntax of the parameter is 'hh:mm', where hh
denotes the hour and mm the minutes. The value must be
enclosed in single apostrophes. For example, '20:18'.
Note:
â– For the parameter to take effect, a device reset is required.
â– The actual update time is randomized by five minutes to
reduce the load on the Web servers.
- 1107 -
To Next Page
Loading...
Need help?
General
