AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ To include the P-Asserted-Identity header in outgoing SIP
UPDATE messages, set the AssertedIDMode parameter to
Add P-Asserted-Identity.
is-cas-sndhook-flsh
[CASSendHookFlash]
Enables sending Wink signal toward CAS trunks.
■ [0] = Disable (default)
■ [1] = Enable
If the device receives a mid-call SIP INFO message with
flashhook event body (as shown below) and the parameter is set
to 1, the device generates a wink signal toward the CAS trunk.
The CAS wink signal is done by changing the A bit from 1 to 0,
and then back to 1 for 450 msec.
INFO sip:4505656002@192.168.13.40:5060
SIP/2.0
Via: SIP/2.0/UDP 192.168.13.2:5060
From: <sip:06@192.168.13.2:5060>
To:
<sip:4505656002@192.168.13.40:5060>;tag=13287
8796-1040067870294
Call-ID: 0010-0016-D69A7DA8-1@192.168.13.2
CSeq:2 INFO
Content-Type: application/broadsoft
Content-Length: 17
event flashhook
Note: The parameter is applicable only to T1 CAS protocols.
Tone Parameters
This subsection describes the device's tone parameters.
Telephony Tone Parameters
The telephony tone parameters are described in the table below.
Table 68-55:Tone Parameters
Parameter Description
'Maximum simultaneous streaming
calls'
max-streaming-calls
[MaxStreamingCalls]
Defines the maximum number of concurrent call parties
that have been placed on hold to which the device can
play Music on Hold (MoH) that originates from an
external media player.
The maximum is 20. The default is 0.
For more information, see Configuring MoH from
External Audio Source on page648.
Note:
■ The parameter is applicable only to FXS interfaces.
■ Each FXS port supports up to 20 concurrent MoH
sessions.
- 1293 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English