AudioCodes E-SBC User Manual

CHAPTER25 Routing
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'Source Tags'
src-tags
[PstnPrefix_SrcTags]
Assigns a Dial Plan tag to denote a group of source URI user names.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure Dial Plan tags, see Configuring Dial Plans.
Note:
■ The tag must belong to the Dial Plan that is assigned for IP-to-Tel
routing. To do this, use the 'IP-to-Tel Dial Plan Name'
(IP2TelDialPlanName) parameter.
■ The device uses the tag before or after manipulation, depending
on the 'IP-to-Tel Routing Mode' (RouteModeIP2Tel) parameter. If
configured to Route calls before manipulation, the tag is used
before manipulation. If configured to Route calls after
manipulation, the tag is used after manipulation.
'Destination Phone
Pattern'
dst-host-pattern
[PstnPrefix_
DestPrefix]
Defines the called (destined) telephone number.
You can use special patterns (notations) to denote the number. For
example, "[100-199](100,101,105)" denotes a number that starts
with 100 to 199 and ends with 100, 101 or 105. To denote any prefix,
use the asterisk (*) symbol (default). To denote calls without a called
number, use the dollar ($) sign. For available patterns, see Dialing
Plan Notation for Routing and Manipulation Tables.
The value can include up to 49 digits.
'Destination Host
Pattern'
dst-phone-
pattern
[PstnPrefix_
DestHostPrefix]
Defines the Request-URI host name of the incoming INVITE
message.
You can use special patterns (notations) to denote the host part. For
example, if you want to match this rule to host parts that end (suffix)
in ".com", then configure this parameter to "(.com)". To denote any
host part, use the asterisk (*) symbol. For available patterns, see
Dialing Plan Notation for Routing and Manipulation Tables.
By default, no value is defined.
'Destination Tags'
dest-tags
[PstnPrefix_
DestTags]
Assigns a prefix tag to denote destination URI user names
corresponding to the tag configured in the associated Dial Plan.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure Dial Plan tags, see Configuring Dial Plans.
Note:
■ The tag must belong to the Dial Plan that is assigned for IP-to-Tel
routing. To do this, use the 'IP-to-Tel Dial Plan Name'
(IP2TelDialPlanName) parameter.
■ The device uses the tag before or after manipulation, depending
on the 'IP-to-Tel Routing Mode' (RouteModeIP2Tel) parameter. If
configured to Route calls before manipulation, the tag is used
before manipulation. If configured to Route calls after
manipulation, the tag is used after manipulation.
Action
'Destination Type' Defines the type of Tel destination.
- 597 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English