AudioCodes E-SBC User Manual

CHAPTER28 Configuring Supplementary Services
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
[ISDNSuppServ_
CFU2PhoneNumber]
■ The parameter is applicable only to BRI interfaces.
■ To enable BRI call forwarding services, see the
BRICallForwardHandling parameter.
■ For more information on configuring local handling of BRI call
forwarding, see Local Handling of BRI Call Forwarding.
'No Reply Time'
no-reply-time
[ISDNSuppServ_
NoReplyTime]
Defines the timeout (in seconds) that if the BRI extension does
not answer before it expires, the device forwards the call to the
phone number as defined by the 'CFNR Phone Number'
parameter (see above).
The default is 30.
Note:
■ The parameter is applicable only to BRI interfaces.
■ To enable BRI call forwarding services, see the
BRICallForwardHandling parameter.
■ For more information on configuring local handling of BRI call
forwarding, see Local Handling of BRI Call Forwarding.
Caller ID
'Caller ID Enabled'
caller-id-enable
[ISDNSuppServ_
IsCallerIDEnabled]
Enables the receipt of Caller ID.
■ [0] Disabled = The device does not send Caller ID
information to the endpoint.
■ [1] Enabled = The device sends Caller ID information to the
endpoint.
'Caller ID Name'
caller-id-number
[ISDNSuppServ_
CallerID]
Defines the caller ID name of the endpoint (sent to the IP side).
The valid value is a string of up to 18 characters.
'Presentation'
presentation-
restricted
[ISDNSuppServ_
IsPresentationRestricted]
Determines whether the endpoint sends its Caller ID information
to the IP when a call is made.
■ [0] Allowed = The device sends the string defined in the
'Caller ID' field when this endpoint makes a Tel-to-IP call.
■ [1] Restricted = The string defined in the 'Caller ID' field is
not sent.
Detecting Collect Calls
The device detects collect calls (reverse charge calls) using any of the following information
elements (IE) in the received Q.931 ISDN Setup message for Tel-to-IP calls:
■ Reverse Charging Indication IE
■ Facility IE
When the device detects a collect call, it adds a proprietary header (X-Siemens-Call-Type: collect
call) to the outgoing SIP INVITE message.
No special configuration is required for the feature.
- 683 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English