AudioCodes E-SBC - Call Cut-Through Parameters

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
[MLPPRoutineRTPDSCP] The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
'RTP DSCP for MLPP Priority'
dscp-4-mlpp-prio
[MLPPPriorityRTPDSCP]
Defines the RTP DSCP for MLPP Priority precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
'RTP DSCP for MLPP Immediate'
dscp-4-mlpp-immed
[MLPPImmediateRTPDSCP]
Defines the RTP DSCP for MLPP Immediate
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
'RTP DSCP for MLPP Flash'
dscp-4-mlpp-flsh
[MLPPFlashRTPDSCP]
Defines the RTP DSCP for MLPP Flash precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
'RTP DSCP for MLPP Flash
Override'
dscp-4-mlpp-flsh-ov
[MLPPFlashOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
'RTP DSCP for MLPP Flash-
Override-Override'
dscp-4-mlpp-flsh-ov-ov
[MLPPFlashOverOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override-
Override precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the
global parameter PremiumServiceClassMediaDiffServ
or as defined in IP Profiles per call.
Call Cut-through Parameters
The call cut-through parameters are described in the table below.
Table 68-47:Call Cut-Through Parameters
Parameter Description
'Enable Calls Cut
Through'
Global parameter enabling FXS endpoints to receive incoming IP
calls while the port is in off-hook state.
- 1261 -