CHAPTER47 Automatic Provisioning
Mediant 1000 Gateway & E-SBC | User's Manual
AutoCmpFileUrl = 'https://www.company.com/sw.cmp'
â—† CLI:
# configure system
(config-system)# automatic update
(automatic-update)# auto-firmware 'http://www.company.com/sw.cmp'
c. Automatic Update of Call Progress Tone file:
â—† ini File:
CptFileURL = 'https://www.company.com/call_progress.dat'
â—† CLI:
# configure system
(config-system)# automatic update
(automatic-update)# call-progress-tones 'http://www.company.com/call_
progress.dat'
d. Automatic Update of ini configuration file:
â—† ini File:
IniFileURL = 'https://www.company.com/config.ini'
â—† CLI:
# configure system
(config-system)# automatic update
(automatic-update)# voice-configuration
'http://www.company.com/config.ini'
e. Enable Cyclical Redundancy Check (CRC) on downloaded ini file:
â—† ini File:
AUPDCheckIfIniChanged = 1
â—† CLI:
# configure system
(config-system)# automatic update
(automatic-update)# crc-check regular
4. Power down and then power up the device.
Automatic Update from Remote Servers
This example describes how to configure the Automatic Update feature where files are stored and
downloaded from different file server types. The example scenario includes the following:
â– NFS server (Version 2) at 10.13.2.10 for storing the CPT file.
â– FTPS server at ftpserver.corp.com for storing the License Key file. The login credentials to the
server are username "root" and password "wheel".
â– HTTP server at www.company.com for storing the configuration file.
- 903 -
To Next Page
Loading...
Need help?
General
