AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Call Waiting Parameters
The call waiting parameters are described in the table below.
Table 68-40:Call Waiting Parameters
Parameter Description
'Enable Call Waiting'
configure voip >
gateway dtmf-supp-
service supp-service-
settings > call-
waiting
[EnableCallWaiting]
Enables the Call Waiting feature.
■ [0] Disable
■ [1] Enable (default)
Digital interfaces: If enabled and the device initiates a Tel-to-
IP call to a destination that is busy, it plays a call waiting
ringback tone to the caller. The tone is played only if the
destination returns a 182 "Queued" SIP response.
FXS interfaces: If enabled, when an FXS interface receives a
call on a busy endpoint, it responds with a 182 response (and
not with a 486 busy). The device plays a call waiting
indication signal. When hook-flash is detected, the device
switches to the waiting call. The device that initiated the
waiting call plays a call waiting ringback tone to the calling
party after a 182 response is received.
Note:
■ The device's Call Progress Tones (CPT) file must include
a Call Waiting ringback tone-- for analog interfaces: (caller
side) and a call waiting tone (called side, FXS only).
■ FXS interfaces: The EnableHold parameter must be
enabled on both the calling and the called side.
■ Analog interfaces: You can use the table parameter
CallWaitingPerPort to enable Call Waiting per port.
■ Analog interfaces: For information on the Call Waiting
feature, see Enabling Call Waiting.
configure voip > sip-
definition settings >
send-180-for-call-
waiting
[Send180ForCallWaiting]
Determines the SIP response code for indicating Call
Waiting.
■ [0] = (Default) Use 182 Queued response to indicate call
waiting.
■ [1] = Use 180 Ringing response to indicate call waiting.
'Number of Call Waiting
Indications'
configure voip >
gateway dtmf-supp-
service supp-service-
settings > nb-of-cw-
ind
[NumberOfWaitingIndication
s]
Defines the number of call waiting indications that are played
to the called telephone that is connected to the device for Call
Waiting.
The valid range is 1 to 100 indications. The default is 2.
Note: The parameter is applicable only to FXS ports.
'Time Between Call Waiting
Indications'
Defines the time (in seconds) between consecutive call
waiting indications for call waiting.
The valid range is 1 to 100. The default is 10.
- 1241 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English