AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure voip >
gateway dtmf-supp-
service supp-service-
settings > time-
between-cw
[TimeBetweenWaitingIndicati
ons]
Note: The parameter is applicable only to FXS ports.
'Time Before Waiting
Indications'
configure voip >
gateway dtmf-supp-
service supp-service-
settings > time-b4-
cw-ind
[TimeBeforeWaitingIndicatio
ns]
Defines the interval (in seconds) before a call waiting
indication is played to the port that is currently in a call.
The valid range is 0 to 100. The default time is 0 seconds.
Note: The parameter is applicable only to FXS ports.
'Waiting Beep Duration'
configure voip >
gateway dtmf-supp-
service supp-service-
settings > waiting-
beep-dur
[WaitingBeepDuration]
Defines the duration (in msec) of call waiting indications that
are played to the port that is receiving the call.
The valid range is 100 to 65535. The default is 300.
Note: The parameter is applicable only to FXS ports.
[FirstCallWaitingToneID] Defines the index of the first Call Waiting Tone in the CPT
file. This feature enables the called party to distinguish
between different call origins (e.g., external versus internal
calls).
There are three ways to use the distinctive call waiting tones:
■ Playing the call waiting tone according to the SIP Alert-
Info header in the received 180 Ringing SIP response. The
value of the Alert-Info header is added to the value of the
FirstCallWaitingToneID parameter.
■ Playing the call waiting tone according to PriorityIndex in
the ToneIndex table parameter.
■ Playing the call waiting tone according to the parameter
“CallWaitingTone#' of a SIP INFO message.
The device plays the tone received in the 'play tone
CallWaitingTone#' parameter of an INFO message plus the
value of the parameter minus 1.
The valid range is -1 to 1,000. The default is -1 (i.e., not used).
Note:
■ The parameter is applicable only to analog interfaces.
■ It is assumed that all Call Waiting Tones are defined in
sequence in the CPT file.
■ SIP Alert-Info header examples:
✔ Alert-Info:<Bellcore-dr2>
- 1242 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English