CHAPTER45 License Key
Mediant 1000 Gateway & E-SBC | User's Manual
Icon Color Description
Red Indicates features from the previous License Key that were not included in
the new License Key and are no longer available.
After you install the License Key (device reset with a save-to-flash), the icons no longer
appear and the License Key page displays only features and capacity of the new
License Key.
Installing a License Key String
You can install a License Key in encrypted string format, through the Web interface.
● The License Key installation process includes a device reset and therefore, is
traffic-affecting. To minimize the disruption of current calls, it is recommended to
perform this procedure during periods of low traffic.
➢ To install a License Key string through Web interface:
1. Open the License Key page (see Viewing the License Key).
2. Back up the currently installed License Key, as a precaution. If the new License Key does not
comply with your requirements, you can re-load this backed-up License Key to restore the
device's original capabilities. For backing up the License Key, see Backing up the License
Key.
3. Copy the License Key string (from the License Key file or e-mail) to your clipboard. Make sure
that you copy only the encrypted string (and not the serial number or any other part of the
string), as shown in the example below:
4. Click Load By String; the Load Feature Key By String dialog box appears.
5. In the text box, paste your License Key string, as shown in the following example:
- 873 -
To Next Page
Loading...
Need help?
General
