AudioCodes E-SBC - HTTP-Based Services

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure voip > sip-
definition settings > ldap-
secondary-key
[MSLDAPSecondaryKey]
'LDAP Cache Service'
configure system > ldap
settings > ldap-cache-enable
[LDAPCacheEnable]
Enables the LDAP cache service.
■ [0] Disable (default)
■ [1] Enable
Note:
■ For the parameter to take effect, a device reset
is required.
■ For more information on LDAP caching, see
Configuring the Device's LDAP Cache.
HTTP-based Services
The HTTP-based service parameters are described in the table below.
Table 68-70:HTTP-based Service Parameters
Parameter Description
'GW Routing Server'
configure voip > gw routing general-
setting > gw-routing-server
[GWRoutingServer]
Enables routing by a Routing
server.
■ [0] Disable (default)
■ [1] Enable
For more information, see
Centralized Third-Party Routing
Server.
Note: The parameter is
applicable only to the Gateway
application.
'Quality Status'
configure system > http-services >
routing-qos-status
[RoutingServerQualityStatus]
Enables QoS-based routing by
the routing server. The device
collects QoS metrics (media and
signaling) and sends them to the
routing server.
■ [0] Disable (default)
■ [1] Enable
For more information, see
Configuring QoS-Based Routing
by Routing Server.
'Quality Status Rate'
configure system > http-services >
routing-qos-status-rate
[RoutingServerQualityStatusRate]
Defines the rate (in sec) at which
the device sends QoS reports to
the routing server.
The valid range is 15-3600. The
default is 60.
- 1370 -