CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Table 68-22:HTTPS Parameters
Parameter Description
'Secured Web Connection
(HTTPS)'
configure system > web >
secured-connection
[HTTPSOnly]
Defines the protocol for accessing the Web interface.
â– [0] HTTP and HTTPS (default)
â– [1] HTTPs Only = Unencrypted HTTP packets are
blocked.
Note: For the parameter to take effect, a device reset is
required.
configure system > web >
https-port
[HTTPSPort]
Defines the local Secured HTTPS port of the device. The
parameter allows secure remote device Web
management from the LAN. To enable secure Web
management from the LAN, configure the desired port.
The valid range is 1 to 65535 (other restrictions may apply
within this range). The default port is 443.
Note: For the parameter to take effect, a device reset is
required.
'Require Client Certificates for
HTTPS connection'
configure system > web >
req-client-cert
[HTTPSRequireClientCertificate]
Enables the requirement of client certificates for HTTPS
connection.
â– [0] Disable = (Default) Client certificates are not
required.
â– [1] Enable = Client certificates are required. The
client certificate must be preloaded to the device and
its matching private key must be installed on the
managing PC. Time and date must be correctly set on
the device for the client certificate to be verified.
Note:
â– For the parameter to take effect, a device reset is
required.
â– For a description on implementing client certificates,
see TLS for Remote Device Management.
SRTP Parameters
The Secure Real-Time Transport Protocol (SRTP) parameters are described in the table below.
Table 68-23:SRTP Parameters
Parameter Description
'Media Security'
configure voip > media security >
media-security-enable
[EnableMediaSecurity]
Enables Secure Real-Time Transport
Protocol (SRTP).
â– [0] Disable (default)
â– [1] Enable
Note:
â– For the parameter to take effect, a
device reset is required.
- 1137 -
To Next Page
Loading...
Need help?
General
