CHAPTER16 Services
Mediant 1000 Gateway & E-SBC | User's Manual
â– HTTP-based OVOC service for AudioCodes equipment located behind NAT that are
managed by the AudioCodes OVOC server: For more information, see Configuring an
HTTP-based OVOC Service on page274
Enabling the HTTP Proxy Application
Before you can configure HTTP- based proxy services, you must enable the HTTP Proxy
application, as described in the following procedure. Once enabled, the Web interface displays
menus in the Navigation pane that are relevant to the HTTP Proxy application.
The HTTP Proxy application is a license-based feature and is available only if it is
included in the License Key installed on the device. For ordering the feature, please
contact the sales representative of your purchased device. For installing a new License
Key, see License Key.
➢ To enable the HTTP Proxy application:
1. Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder >
General Settings).
2. From the 'HTTP Proxy Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take effect.
Debugging Remote HTTP Services
You can enable the device to generate debug messages for remote Web (HTTP) services and have
them sent to a Syslog server.
➢ To enable debugging of HTTP services:
1. Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder >
General Settings):
2. From the 'HTTP Proxy Debug Level' drop-down list, select a begug level.
3. Click Apply.
Configuring a DNS Server for HTTP Services
You can configure the DNS server (primary and secondary for redundancy) that you want to use for
your HTTP services. If you configure a proxy server with an FQDN, this is the DNS server that the
device uses for resolving the domain name into an IP address.
➢ To configure DNS servers for HTTP services:
1. Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder >
General Settings):
- 259 -
To Next Page
Loading...
Need help?
General
