AudioCodes E-SBC

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure voip >
sip-definition
settings > calls-
cut-through
[CutThrough]
You can also configure the feature per specific calls, using Tel
Profiles (TelProfile_IP2TelCutThroughCallBehavior). For a detailed
description of the parameter and for configuring the feature in the Tel
Profiles table, see Configuring Tel Profiles.
Note:
■ The parameter is applicable only to FXS interfaces.
■ If the feature is configured for a specific Tel Profile, the settings
of the global parameter is ignored for calls associated with the
Tel Profile.
cut-through-
anable
[DigitalCutThrough]
Global parameter enabling PSTN CAS channels/endpoints to
receive incoming IP calls even if the B-channels are in off-hook
state.
You can also configure the feature per specific calls, using Tel
Profiles (TelProfile_DigitalCutThrough). For a detailed description of
the parameter and for configuring the feature in the Tel Profiles
table, see Configuring Tel Profiles.
Note:
■ If the feature is configured for a specific Tel Profile, the settings
of the global parameter is ignored for calls associated with the
Tel Profile.
■ The parameter is applicable only to digital interfaces (CAS).
Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 68-48:DID Parameters
Parameter Description
'DID Wink'
configure voip >
sip-definition
settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using
Wink-Start signaling, typically used for signaling between an E-
911 switch and the PSAP.
You can also configure the feature per specific calls, using Tel
Profiles (TelProfile_EnableDIDWink). For a detailed description
of the parameter and for configuring the feature in the Tel Profiles
table, see Configuring Tel Profiles.
Note:
■ The parameter is applicable to FXS and FXO interfaces.
■ If the feature is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls
associated with the Tel Profile.
'Time Between DID Winks'
configure voip >
sip-definition
settings > time-
between-did-winks
[TimeBetweenDIDWinks]
Defines the interval (in msec) for wink signaling:
■ Double-wink signaling [2]: interval between the first and
second wink
■ Wink and Polarity signaling [3]: interval between wink and
polarity change
The valid range is 100 to 2000. The default is 1000.
- 1262 -