CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
✔ Interdigit Timeout (TimeBetweenDigits)
expires
✔ Pound (#) key is pressed
✔ Digit map pattern is matched
'Inter Digit Timeout for Overlap Dialing'
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> time-btwn-dial-digs
[TimeBetweenDigits]
Analog: Defines the time (in seconds) that the
device waits between digits that are dialed by the
user.
ISDN overlap dialing: Defines the time (in
seconds) that the device waits between digits
that are received from the PSTN or IP during
overlap dialing.
When this inter-digit timeout expires, the device
uses the collected digits to dial the called
destination number.
The valid range is 1 to 10. The default is 4.
'Enable Special Digits'
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> special-digits
[IsSpecialDigits]
Enables the use of the asterisk (*) and pound (#)
digits in dialed telephone numbers.
â– [0] Disable = Use '*' or '#' to terminate
number collection (refer to the parameter
UseDigitForSpecialDTMF). (Default.)
â– [1] Enable = Allows '*' and '#' for telephone
numbers dialed by a user or for the endpoint
telephone number.
Note:
â– The symbols can always be used as the first
digit of a dialed number even if you disable the
parameter.
â– The parameter is applicable only to analog
interfaces.
Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the Voice Mail
application, refer to the CPE Configuration Guide for Voice Mail.
Table 68-38:Voice Mail Parameters
Parameter Description
'Voice Mail Interface'
configure voip > gateway
voice-mail-setting > vm-
interface
[VoiceMailInterface]
Enables the device's Voice Mail application and
determines the communication method between
the device and PBX.
â– [0] None (default)
â– [1] DTMF
â– [2] SMDI
â– [3] QSIG
â– [4] SETUP Only = Applicable only to ISDN.
- 1229 -
To Next Page
Loading...
Need help?
General
