EasyManuals Logo

AudioCodes E-SBC User Manual

AudioCodes E-SBC
1414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1268 background imageLoading...
Page #1268 background image
CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
â–  [5] MATRA/AASTRA QSIG
â–  [6] QSIG SIEMENS = QSIG MWI activate and
deactivate messages include Siemens
Manufacturer Specific Information (MSI)
â–  [8] ETSI = Euro ISDN, according to ETS 300
745-1 V1.2.4, section 9.5.1.1. Enables MWI
interworking from IP to Tel , typically used for
BRI phones.
â–  [9] NI2 = ISDN PRI trunks set to NI-2. This is
used for interworking the SIP Message Waiting
Indication (MWI) NOTIFY message to ISDN
PRI NI-2 Message Waiting Notification (MWN)
that is sent in the ISDN Facility IE message.
This option is applicable when the device is
connected to a PBX through an ISDN PRI trunk
configured to NI-2.
Note: To disable voice mail per Trunk Group, you
can use a Tel Profile with the
EnableVoiceMailDelay parameter set to disabled
(0). This eliminates the phenomenon of call delay
on Trunks not implementing voice mail when voice
mail is enabled using this global parameter.
'Enable VoiceMail URI'
voicemail-uri
[EnableVMURI]
Enables the interworking of target and cause for
redirection from Tel to IP and vice versa, according
to RFC 4468.
â–  [0] Disable (default)
â–  [1] Enable
Digital interfaces: Upon receipt of an ISDN Setup
message with Redirect values, the device maps
the Redirect phone number to the SIP 'target'
parameter and the Redirect number reason to the
SIP 'cause' parameter in the Request-URI.
Redirecting Reason >> SIP Response Code
Unknown >> 404
User busy >> 486
No reply >> 408
Deflection >> 487/480
Unconditional >> 302
Others >> 302
If the device receives a Request-URI that includes
a 'target' and 'cause' parameter, the 'target' is
mapped to the Redirect phone number and the
'cause' is mapped to the Redirect number reason.
[WaitForBusyTime] Defines the time (in msec) that the device waits to
detect busy and/or reorder tones. This feature is
used for semi-supervised PBX call transfers (i.e.,
the LineTransferMode parameter is set to 2).
- 1230 -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes E-SBC and is the answer not in the manual?

AudioCodes E-SBC Specifications

General IconGeneral
BrandAudioCodes
ModelE-SBC
CategoryGateway
LanguageEnglish

Related product manuals