AudioCodes E-SBC

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ If the feature is configured for a specific Tel Profile,
the settings of the global parameter is ignored for
calls associated with the Tel Profile.
■ The parameter is applicable only to FXS interfaces.
'MWI Display'
configure voip > gateway
dtmf-supp-service supp-
service-settings >
enable-mwi
[MWIDisplay]
Global parameter enabling the sending of MWI
information to the phone display.
You can also configure the feature per specific calls,
using Tel Profiles (TelProfile_MWIDisplay). For a
detailed description of the parameter and for configuring
the feature in the Tel Profiles table, see Configuring Tel
Profiles.
Note:
■ If the feature is configured for a specific Tel Profile,
the settings of the global parameter is ignored for
calls associated with the Tel Profile.
■ The parameter is applicable only to FXS interfaces.
'Subscribe to MWI'
configure voip > gateway
dtmf-supp-service supp-
service-settings >
subscribe-to-mwi
[EnableMWISubscription]
Enables subscription to an MWI server.
■ [0] No (default)
■ [1] Yes
Note:
■ To configure the MWI server address, use the
MWIServerIP parameter.
■ To configure whether the device subscribes per
endpoint or per the entire device, use the parameter
SubscriptionMode.
'MWI Server IP Address'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
srvr-ip-addr
[MWIServerIP]
Defines the MWI server's IP address. If provided, the
device subscribes to this IP address. The MWI server
address can be configured as a numerical IP address or
as a domain name. If not configured, the Proxy IP
address is used instead.
'MWI Server Transport Type'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
srvr-transp-type
[MWIServerTransportType]
Determines the transport layer used for outgoing SIP
dialogs initiated by the device to the MWI server.
■ [-1] Not Configured (default)
■ [0] UDP
■ [1] TCP
■ [2] TLS
Note: When set to ‘Not Configured’, the value of the
parameter SIPTransportType is used.
'MWI Subscribe Expiration Time'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
subs-expr-time
Defines the MWI subscription expiration time in
seconds.
The default is 7200 seconds. The range is 10 to
2,000,000.
- 1245 -