AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'AMD Beep Detection Mode'
configure voip > sip-
definition settings > amd-
beep-detection
[AMDBeepDetectionMode]
Defines the AMD beep detection mode. This mode
detects the beeps played at the end of an answering
machine message, by using the X-Detect header
extension. The device sends a SIP INFO message
containing the field values 'Type=AMD' and
'SubType=Beep'. This feature allows users of certain
third-party, Application servers to leave a voice
message after an answering machine plays the “beep”.
■ [0] Disabled (default)
■ [1] Start After AMD
■ [2] Start Immediately
'Answer Machine Detector Beep
Detection Timeout'
configure voip > media
ipmedia > amd-beep-
detection-timeout
[AMDBeepDetectionTimeout]
Defines the AMD beep detection timeout (i.e., the
duration that the beep detector functions from when
detection is initiated). This is used for detecting beeps
at the end of an answering machine message.
The valid value is in units of 100 milliseconds, from 0
to 1638. The default is 200 (i.e., 20 seconds).
'Answer Machine Detector Beep
Detection Sensitivity'
configure voip > media
ipmedia > amd-beep-
detection-sensitivity
[AMDBeepDetectionSensitivity]
Defines the AMD beep detection sensitivity for
detecting beeps at the end of an answering machine
message.
The valid value is 0 to 3, where 0 (default) is the least
sensitive.
early-amd
[EnableEarlyAMD]
Enables AMD detection to be activated upon receipt of
an ISDN Alerting or Connect message.
■ [0] = (Default) Disable - AMD is activated upon
receipt of ISDN Connect message.
■ [1] = Enable - AMD is activated upon receipt of
ISDN Alerting message.
Note: The parameter is applicable only to the Gateway
application (digital interfaces).
'AMD Mode'
configure voip > sip-
definition settings > amd-
mode
[AMDmode]
Global parameter that enables the device to
disconnect the IP-to-Tel call upon detection of an
answering machine on the Tel side. You can also
configure this feature per specific calls, using IP
Profiles (IpProfile_AmdMode). For a detailed
description of the parameter and for configuring this
feature in the IP Profiles table, see Configuring IP
Profiles.
Note:
■ The parameter is applicable only to the Gateway
application (digital interfaces).
■ If this feature is configured for a specific IP Profile,
the settings of this global parameter is ignored for
calls associated with the IP Profile.
- 1363 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English