AudioCodes E-SBC

CHAPTER58 Syslog and Debug Recording
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ If you configure the parameter to Syslog Server and the debug
level, using the [GwDebugLevel] parameter, is configured to No
Debug (see Configuring Syslog Debug Level), the Syslog
messages include only system Warnings and Errors.
■ If you configure the parameter to Debug Recording Server,
you can also include Syslog messages in the debug recording
packets sent to the debug recording server. To include Syslog
messages, configure the 'Log Type' parameter (see below) to
the relevant option.
'Log Type'
log-type
[LoggingFilters_
CaptureType]
Defines the type of messages to include in the log file.
■ [0] = (Default) Not configured. The option is applicable only for
sending Syslog messages to a Syslog server (i.e., 'Log
Destination' parameter is configured to Syslog Server).
■ [1] Signaling = The option is applicable only to debug recording
(i.e., 'Log Destination' parameter is configured to Debug
Recording Server). The debug recording includes signaling
information such as SIP signaling messages, Syslog
messages, CDRs, and the device's internal processing
messages.
■ [2] Signaling & Media = The option is applicable only to debug
recording (i.e., 'Log Destination' parameter is configured to
Debug Recording Server). The debug recording includes
media (RTP/RTCP/T.38), and only signaling and Syslog
messages associated with the recorded media.
Note: The device requires a lot of resources for media debug
recording. The number of media sessions (and associated sig-
naling) that the device records depends on available resources.
Therefore, when many media sessions need to be recorded
(e.g., when the 'Filter Type' parameter is configured to Any) not
all media sessions (and associated signaling) are recorded. If
the device has no resources to debug record any media, it
doesn't debug record any signaling as well. As debug recording
of signaling requires less resources than media debug record-
ing, if you want to perform debug recording only on signaling,
then it is recommended to configure the parameter to
Signaling.
■ [3] Signaling & Media & PCM = The option is applicable only
to debug recording (i.e., 'Log Destination' parameter is
configured to Debug Recording Server). The debug recording
includes signaling, Syslog messages, media, and PCM (voice
signals from and to TDM).
■ [4] PSTN Trace = The option is applicable only to debug
recording (i.e., 'Log Destination' parameter is configured to
Debug Recording Server) and if the 'Filter Type' parameter is
configured to Trunk ID. The debug recording includes ISDN
and CAS traces.
Note:
✔ This option is applicable only to digital interfaces.
- 1038 -