CHAPTER58 Syslog and Debug Recording
Mediant 1000 Gateway & E-SBC | User's Manual
14:42:48.334 : 10.15.7.95 : NOTICE : [S=3546] [BID=3aad56:32] Activity Log:
Classification - remove line 2. User: Admin. Session: HTTP (10.13.22.54)
â– Entered CLI commands (modifications of security-sensitive commands are logged without the
entered value).
â– Configuration file load (reported without per-parameter notifications).
â– Auxiliary file load and software update.
â– Device reset and burn to flash memory.
â– Access to unauthorized Web pages according to the Web user's access level.
â– Modifications of "sensitive" parameters.
â– Login and logout.
â– Actions not related to parameter changes (for example, file uploads, file delete, lock-unlock
maintenance actions, LDAP clear cache, register-unregister, and start-stop trunk). In the Web,
these actions are typically done by clicking a button (e.g., the LOCK button).
For more information on each of the above listed options, see Syslog, CDR and Debug
Parameters.
The following procedure describes how to configure management user activity logging through the
Web interface. You can also configure it through ini file [ActivityListToLog] or CLI (configure
troubleshoot > activity-log).
➢ To configure reporting of management user activities:
1. Open the Logging Settings page (Troubleshoot tab > Troubleshoot menu > Logging folder >
Logging Settings).
2. Under the Activity Types to Report group, select the actions to report to the Syslog server. To
select (or deselect) all activity types, click the 'Select All' check box.
3. Click Apply.
- 1049 -
To Next Page
Loading...
Need help?
General
