AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
configure system > cli-
settings > telnet
[TelnetServerEnable]
■ [0] Disable
■ [1] Enable Unsecured (default)
■ [2] Enable Secured
Note: Only management users with Security Administrator
or Master user levels can access the CLI's Privileged
command mode.
'Telnet Server TCP Port'
configure system > cli-
settings > telnet-port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is
23.
'Telnet Server Idle Timeout'
configure system > cli-
settings > idle-timeout
[TelnetServerIdleDisconnect]
Defines the duration of an idle CLI (Telnet or SSH) session
after which the session is automatically disconnected.
The valid range is any value. The default is 5. When
configured to 0, idle sessions are not disconnected.
Note: If you change the parameter's value when there are
current Telnet/SSH sessions, the parameter's previous
setting is still applied to these current sessions and the
parameter's new setting is applied only to new sessions.
'Maximum Telnet Sessions'
configure system > cli-
settings > telnet-max-
sessions
[TelnetMaxSessions]
Defines the maximum number of permitted, concurrent
Telnet or SSH sessions.
The valid range is 1 to 5 sessions. The default is 2.
Note: Before changing the value, make sure that not more
than this number of sessions are currently active;
otherwise, the new setting will not take effect.
[CLIEnableModePassword] Defines the password to access the Enable configuration
mode in the CLI.
The valid value is a string of up to 50 characters. The
default is "Admin".
Note: The password is case-sensitive.
'Default Terminal Window
Height'
configure system > cli-
settings > default-
window-height
[DefaultTerminalWindowHeight]
Defines the number (height) of output lines displayed in the
CLI terminal window. This applies to all new CLI sessions
and is preserved after device resets.
The valid value range is -1 (default) and 0-65535:
■ A value of -1 means that the parameter is disabled and
the settings of the CLI command window-height is
used.
■ A value of 0 means that all the CLI output is displayed
in the window.
■ A value of 1 or greater displays that many output lines in
the window and if there is more output, the “—MORE—
" prompt is displayed. For example, if you configure the
parameter to 4, up to four output lines are displayed in
the window and if there is more output, the “—MORE—
" prompt is displayed (at which you can press the
spacebar to display the next four output lines).
- 1097 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English