CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
✔ Configure E1/T1 Transparent protocol type (set the
ProtocoType parameter to 5 or 6).
✔ Enable the TDM-over-IP feature (set the
EnableTDMoverIP parameter to 1).
â– To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_x parameter.
â– If per trunk configuration (using the RTPOnlyModeForTrunk_
ID parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
[RTPOnlyModeForTrunk_
x]
Enables the RTP Only feature per trunk. The x in the parameter
name denotes the trunk number, where 0 is Trunk 1. For a
description of the parameter, see the RTPOnlyMode parameter.
Note: For using the global parameter (i.e., setting the RTP Only
feature for all trunks), set the parameter to -1 (default).
'Media IP Version
Preference'
media-ip-ver-pref
[MediaIPVersionPreferen
ce]
Global parameter that defines the preferred RTP media IP
addressing version (IPv4 or IPv6) for outgoing SIP calls. You can
also configure this feature per specific calls, using IP Profiles
(IpProfile_MediaIPVersionPreference). For a detailed description
of the parameter and for configuring this feature in the IP Profiles
table, see Configuring IP Profiles.
'SIT Q850 Cause'
configure voip >
sip-definition
settings > sit-
q850-cause
[SITQ850Cause]
Defines the Q.850 cause value specified in the SIP Reason
header that is included in a 4xx response when a Special
Information Tone (SIT) is detected on an IP-to-Tel call.
The valid range is 0 to 127. The default is 34.
Note: For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC,
SITQ850CauseForVC, and SITQ850CauseForRO parameters.
'SIT Q850 Cause For NC'
configure voip >
sip-definition
settings > release-
cause-for-sit-nc
[SITQ850CauseForNC]
Defines the Q.850 cause value specified in the SIP Reason
header that is included in a 4xx response when SIT-NC (No
Circuit Found Special Information Tone) is detected from the Tel
side for IP-to-Tel calls.
The valid range is 0 to 127. The default is 34.
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
'SIT Q850 Cause For IC'
configure voip >
sip-definition
settings > q850-
cause-for-sit-ic
[SITQ850CauseForIC]
Defines the Q.850 cause value specified in the SIP Reason
header that is included in a 4xx response when SIT-IC (Operator
Intercept Special Information Tone) is detected from the Tel for
IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
'SIT Q850 Cause For VC' Defines the Q.850 cause value specified in the SIP Reason
header that is included in a 4xx response when SIT-VC (Vacant
Circuit - non-registered number Special Information Tone) is
detected from the Tel for IP-to-Tel calls.
- 1194 -
To Next Page
Loading...
Need help?
General
