CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
â– If the device is located in a network subnet which
is connected to other gateways using a router that
uses Virtual Router Redundancy Protocol (VRRP)
for redundancy, then set the parameter to 0 or 2.
'Forward Invalid RTP Packets'
[RTPFWInvalidPacketHandling]
Defines the device's handling of invalid RTP and
RTCP packets.
â– [0] Forward Packets = Forwards the invalid
packets as is.
â– [1] Forward Packets and Issue Warnings =
(Default) Forwards the invalid packets and issues
warnings (sent to the Syslog) to notify of the
invalid packets.
â– [2] Drop Packets and Issue Warnings = Drops
the invalid packets and issues warnings to notify
of the invalid packets.
Note:
â– The parameter is applicable only if the IPProfile_
TranscodingMode parameter is configured to RTP
Forwarding.
â– The parameter is applicable only to the SBC
application.
'Forward Unknown RTP Payload
Types'
[RtpFWNonConfiguredPTHandling]
Defines the device's handling of RTP packets that are
received with non-configured (unknown) payload
types.
â– [0] Handle as Invalid Packet = (Default) Handles
the packet as an invalid packet, according to the
RTPFWInvalidPacketHandling parameter.
â– [1] Handle as Valid Packet = Handles the packet
as a valid packet.
Note:
â– The parameter is applicable only if the IPProfile_
TranscodingMode parameter is configured to RTP
Forwarding.
â– The parameter is applicable only to the SBC
application.
'RTP Base UDP Port'
configure voip > media rtp-
rtcp > base-udp-port
[BaseUDPport]
Global parameter that defines the lower boundary of
the UDP port used for RTP, RTCP (RTP port + 1) and
T.38 (RTP port + 2). For more information on
configuring the UDP port range, see Configuring RTP
Base UDP Port.
The range of possible UDP ports is 6,000 to 64,000.
The default base UDP port is 6000.
Note: For the parameter to take effect, a device reset
is required.
- 1207 -
To Next Page
Loading...
Need help?
General
