AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Note: For the parameter to take effect, a device reset
is required.
'Minimum Gap Size'
[VQMonGMin]
Defines the voice quality monitoring - minimum gap
size (number of frames).
The default is 16.
'Burst Threshold'
[VQMonBurstHR]
Defines the voice quality monitoring - excessive burst
alert threshold.
The default is -1 (i.e., no alerts are issued).
'Delay Threshold'
[VQMonDelayTHR]
Defines the voice quality monitoring - excessive delay
alert threshold.
The default is -1 (i.e., no alerts are issued).
'R-Value Delay Threshold'
[VQMonEOCRValTHR]
Defines the voice quality monitoring - end of call low
quality alert threshold.
The default is -1 (i.e., no alerts are issued).
'Tx RTCP Packets Interval'
configure voip > media rtp-
rtcp > rtcp-interval
[RTCPInterval]
Defines the time interval (in msec) between adjacent
RTCP XR reports. This interval starts from call
establishment. Thus, the device can send RTCP XR
reports during the call, in addition to at the end of the
call. If the duration of the call is shorter than this
interval, RTCP XR is sent only at the end of the call.
The valid value range is 0 to 65,535. The default is
5,000.
'Disable RTCP XR Interval
Randomization'
configure voip > media rtp-
rtcp > disable-RTCP-
randomization
[DisableRTCPRandomize]
Determines whether RTCP report intervals are
randomized or whether each report interval accords
exactly to the parameter RTCPInterval.
■ [0] Disable = (Default) Randomize
■ [1] Enable = No Randomize
'Gateway RTCP XR Report Mode'
configure voip > sip-
definition settings > rtcp-
xr-rep-mode
[RTCPXRReportMode]
Enables the device to send RTCP XR in SIP
PUBLISH messages and defines the interval at which
they are sent.
■ [0] Disable = (Default) RTCP XR is not sent.
■ [1] End Call = RTCP XR is sent at the end of the
call.
■ [2] End Call & Periodic = RTCP XR is sent at
the end of the call and periodically according to the
RTCPInterval parameter.
- 1210 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English