AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Table 68-39:Caller ID Parameters
Parameter Description
'Enable Caller ID'
configure voip >
gateway dtmf-supp-
service supp-service-
settings > enable-
caller-id
[EnableCallerID]
Global parameter that enables Caller ID.
■ [0] Disable (default)
■ [1] Enable =
✔ FXS: The calling number and display text (from IP)
are sent to the device's port.
✔ FXO and CAS: The device detects the Caller ID
signal received from the Tel and sends it to the IP in
the SIP INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring
Caller Display Information. To enable or disable caller ID
generation / detection per port, see Configuring Caller ID
Permissions.
'Caller ID Type'
configure voip >
gateway dtmf-supp-
service supp-service-
settings > caller-id-
type
[CallerIDType]
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) /
generation (FXS) of MWI (when specified) signals:
■ [0] Standard Bellcore = (Default) Caller ID and MWI
■ [1] Standard ETSI = Caller ID and MWI
■ [2] Standard NTT
■ [4] Standard BT = Britain
■ [16] Standard DTMF Based ETSI
■ [17] Standard Denmark = Caller ID and MWI
■ [18] Standard India
■ [19] Standard Brazil
Note:
■ The parameter is applicable only to analog interfaces.
■ Typically, the Caller ID signals are generated / detected
between the first and second rings. However, sometimes
the Caller ID is detected before the first ring signal. In
such a scenario, set the RingsBeforeCallerID parameter
to 0.
■ Caller ID detection for Britain [4] is not supported on the
device’s FXO ports. Only FXS ports can generate the
Britain [4] Caller ID.
■ To select the Bellcore Caller ID sub standard, use the
BellcoreCallerIDTypeOneSubStandard parameter. To
select the ETSI Caller ID substandard, use the
ETSICallerIDTypeOneSubStandard parameter.
■ To select the Bellcore MWI sub standard, use the
BellcoreVMWITypeOneStandard parameter. To select
the ETSI MWI sub standard, use the
ETSIVMWITypeOneStandard parameter.
■ If you define Caller ID Type as NTT [2], you need to
define the NTT DID signaling form (FSK or DTMF) using
the NTTDIDSignallingForm parameter.
- 1237 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English