AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
■ [0] = Caller ID type 2 isn't played.
■ [1] = (Default) Caller ID type 2 is played.
Note: The parameter is applicable only to FXS interfaces.
configure voip >
interface fxs-fxo >
caller-id-timing-mode
[AnalogCallerIDTimingMode]
Determines when Caller ID is generated.
■ [0] = (Default) Caller ID is generated between the first two
rings.
■ [1] = The device attempts to find an optimized timing to
generate the Caller ID according to the selected Caller ID
type.
Note:
■ The parameter is applicable only to FXS interfaces.
■ If the parameter is set to 1 and used with distinctive
ringing, the Caller ID signal doesn't change the distinctive
ringing timing.
■ For the parameter to take effect, a device reset is
required.
configure voip >
interface fxs-fxo >
bellcore-callerid-
type-one-sub-standard
[BellcoreCallerIDTypeOneSu
bStandard]
Determines the Bellcore Caller ID sub-standard.
■ [0] = (Default) Between rings.
■ [1] = Not ring related.
Note:
■ For the parameter to take effect, a device reset is
required.
■ The parameter is applicable only to FXS interfaces.
configure voip >
interface fxs-fxo >
etsi-callerid-type-
one-sub-standard
[ETSICallerIDTypeOneSubSt
andard]
Determines the ETSI FSK Caller ID Type 1 sub-standard
(FXS only).
■ [0] = (Default) ETSI between rings.
■ [1] = ETSI before ring DT_AS.
■ [2] = ETSI before ring RP_AS.
■ [3] = ETSI before ring LR_DT_AS.
■ [4] = ETSI not ring related DT_AS.
■ [5] = ETSI not ring related RP_AS.
■ [6] = ETSI not ring related LR_DT_AS.
Note:
■ For the parameter to take effect, a device reset is
required.
■ The parameter is applicable only to FXS interfaces.
'Asserted Identity Mode'
asserted-identity-m
[AssertedIdMode]
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is added to the sent INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers
are used to present the calling party's Caller ID, which is
composed of a Calling Number and a Calling Name (optional).
■ [0] Disabled = (Default) P-Asserted-Identity and P-
Preferred-Identity headers are not added.
- 1239 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English