AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
blind-xfer-add-prefix
[KeyBlindTransferAddPrefix]
Determines whether the device adds the Blind
Transfer code (defined by the KeyBlindTransfer
parameter) to the dialed destination number.
■ [0] = Disable (default)
■ [1] = Enable
Note: The parameter is applicable only to analog
interfaces.
blind-xfer-disc-tmo
[BlindTransferDisconnectTimeout]
Defines the duration (in milliseconds) for which the
device waits for a disconnection from the Tel side after
the Blind Transfer Code (KeyBlindTransfer) has been
identified. When this timer expires, a SIP REFER
message is sent toward the IP side. If the parameter is
set to 0, the REFER message is immediately sent.
The valid value range is 0 to 1,000,000. The default is
0.
'QSIG Path Replacement Mode'
qsig-path-replacement-md
[QSIGPathReplacementMode]
Enables QSIG transfer for IP-to-Tel and Tel-to-IP
calls.
■ [0] IP2QSIGTransfer = (Default) Enables IP-to-
QSIG transfer.
■ [1] QSIG2IPTransfer = Enables QSIG-to-IP
transfer.
Note: The parameter is applicable only to digital
interfaces.
replace-tel2ip-calnum-to
[ReplaceTel2IPCallingNumTimeout]
Defines the maximum duration (timeout) to wait
between call Setup and Facility with Redirecting
Number for replacing the calling number (for Tel-to-IP
calls).
The valid value range is 0 to 10,000 msec. The default
is 0.
The interworking of the received Setup message to a
SIP INVITE is suspended when the parameter is set
to any value greater than 0. This means that the
redirecting number in the Setup message is not
checked. When a subsequent Facility with Call
Transfer Complete/Update is received with a non-
empty Redirection Number, the Calling Number is
replaced with the received redirect number in the sent
INVITE message.
If the timeout expires, the device sends the INVITE
without changing the calling number.
Note:
■ The suspension of the INVITE message occurs for
all calls.
■ The parameter is applicable only to QSIG.
'Call Transfer using re-INVITEs' Enables call transfer using re-INVITEs.
- 1250 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English