CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
'Stutter Tone Duration'
configure voip > gateway
dtmf-supp-service supp-
service-settings > sttr-
tone-duration
[StutterToneDuration]
Defines the duration (in msec) of the confirmation tone.
A stutter tone is played (instead of a regular dial tone)
when a Message Waiting Indication (MWI) is received.
The stutter tone is composed of a confirmation tone
(Tone Type #8), which is played for the defined duration
(StutterToneDuration) followed by a stutter dial tone
(Tone Type #15). Both these tones are defined in the
CPT file.
The range is 1,000 to 60,000. The default is 2,000 (i.e.,
2 seconds).
Note:
■ The parameter is applicable only to FXS interfaces.
■ If you want to configure the duration of the
confirmation tone to longer than 16 seconds, you
must increase the value of the parameter
TimeForDialTone accordingly.
■ The MWI tone overrides the call forwarding
reminder tone. For more information on MWI, see
Message Waiting Indication.
'FXO AutoDial Play BusyTone'
configure voip > gateway
analog fxo-setting > fxo-
autodial-play-bsytn
[FXOAutoDialPlayBusyTone]
Determines whether the device plays a busy / reorder
tone to the PSTN side if a Tel-to-IP call is rejected by a
SIP error response (4xx, 5xx or 6xx). If a SIP error
response is received, the device seizes the line (off-
hook), and then plays a busy / reorder tone to the PSTN
side (for the duration defined by the parameter
TimeForReorderTone). After playing the tone, the line is
released (on-hook).
■ [0] = Disable (default)
■ [1] = Enable
Note: The parameter is applicable only to FXO
interfaces.
'Hotline Dial Tone Duration'
configure voip > gateway
dtmf-supp-service dtmf-
and-dialing > hotline-dt-
dur
[HotLineToneDuration]
Defines the duration (in seconds) of the hotline dial
tone. If no digits are received during this duration, the
device initiates a call to a user-defined number
(configured in the Automatic Dialing table -
TargetOfChannel - see Configuring Automatic Dialing).
The valid range is 0 to 60. The default is 16.
Note:
■ The parameter is applicable only to analog
interfaces.
■ You can define the Hotline duration per FXS /FXO
port using the Automatic Dialing table.
'Reorder Tone Duration'
configure voip > gateway
analog fxo-setting >
reorder-tone-duration
[TimeForReorderTone]
Global parameter defining the duration (in seconds) that
the device plays a busy or reorder tone before releasing
the line.
- 1295 -
To Next Page
Loading...
