AudioCodes E-SBC User Manual

CHAPTER68 Configuration Parameters Reference
Mediant 1000 Gateway & E-SBC | User's Manual
Parameter Description
Note:
■ The parameter is applicable only to analog
interfaces.
■ The parameter is applicable only if silence is
detected according to packet count
(FarEndDisconnectSilenceMethod is set to 1).
■ For the parameter to take effect, a device reset is
required.
[BrokenConnectionDuringSilence] Enables the generation of the BrokenConnection
event during a silence period if the channel’s NoOp
feature is enabled (by the [NoOpEnable] parameter)
and if the channel stops receiving NoOp RTP
packets.
■ [0] = Disable (default)
■ [1] = Enable
Note: The parameter is applicable only to the
Gateway application.
'Trunk Alarm Call Disconnect
Timeout'
trk-alrm-call-disc-to
[TrunkAlarmCallDisconnectTimeout]
Defines the duration (in seconds) to wait after a digital
trunk "Red" alarm (LOS / LOF) is raised, before the
device disconnects the SIP call. If this timeout
expires and the alarm is still raised, the device sends
a SIP BYE message to terminate the call. If the alarm
is cleared before this timeout expires, the call is not
terminated, but continues as normal.
The range is 1 to 3600. The default is 0 (20 for BRI, 20
for E1 and 40 for T1).
Note: The parameter is applicable only to the
Gateway application.
'Disconnect Call on Busy Tone
Detection (ISDN)'
disc-on-bsy-tone-i
[ISDNDisconnectOnBusyTone]
Determines whether a call is disconnected upon
detection of a busy tone (for ISDN).
■ [0] Disable = (Default) Do not disconnect call
upon detection of busy tone.
■ [1] Enable = Disconnect call upon detection of
busy tone.
Note:
■ The parameter is applicable only to ISDN
protocols.
■ IP-to-ISDN calls are disconnected on detection of
SIT tones only in call alert state. If the call is in
connected state, the SIT does not disconnect the
calls. Detection of busy or reorder tones
disconnects the IP-to-ISDN calls also in call
connected state.
■ For IP-to-CAS calls, detection of busy, reorder, or
SIT tones disconnect the calls in any call state.
- 1332 -

AudioCodes E-SBC Specifications

General

Brand	AudioCodes
Model	E-SBC
Category	Gateway
Language	English