CHAPTER17 Quality of Experience
Mediant 1000 Gateway & E-SBC | User's Manual
Table 17-5: Threshold Crossings based on Threshold and Hysteresis
Threshold
Crossing
Calculation
Threshold
based on
Example
Green to
Yellow (Minor
alarm)
The change occurs if the current bandwidth crosses the
configured Minor threshold only (i.e., hysteresis is not
used).
32,000 Kbps
Green to Red
(Major alarm)
The change occurs if the current bandwidth crosses the
configured Major threshold only (i.e., hysteresis is not
used).
64,000 Kbps
Yellow to Red
(Major alarm)
The change occurs if the current bandwidth crosses the
configured Major threshold only (i.e., hysteresis is not
used).
64,000 Kbps
Red to Yellow
(Minor alarm)
The change occurs if the current bandwidth crosses the
configured Major threshold with hysteresis.
57,600 Kbps
[64,000 - (10% x
64,000)]
Yellow to
Green (alarm
cleared)
The change occurs if the current bandwidth crosses the
configured Minor threshold with hysteresis.
25,600 Kbps
[32,000 - (10% x
64,000)]
Red to Green
(alarm cleared)
The change occurs if the current bandwidth crosses the
configured Minor threshold with hysteresis.
25,600 Kbps
[32,000 - (10% x
64,000)]
The following procedure describes how to configure Bandwidth Profiles through the Web interface.
You can also configure it through ini file [BWProfile] or CLI (configure voip > qoe bw-
profile).
➢ To configure a Bandwidth Profile:
1. Open the Bandwidth Profile table (Setup menu > Signaling & Media tab > Media folder >
Quality of Experience > Bandwidth Profile).
2. Click New; the following dialog box appears:
- 309 -
To Next Page
Loading...
Need help?
General
